Dresser TV stands -.Mounting the TV on a wall bracket is practical and simple at the same time. It is not only space saving, achieved by far but also the economic savings in both cost a lot less money supports a new table or sideboard. At the same time, the minimalism of the support is completely in tune with the current design dresser TV stand. Another advantage of dresser TV stand holders is that you can adjust the height in place that everyone wants. If you are already determined to do it yourself, you should know that the market can find various models of media, according to the size of the screen of your device, according to whether permitted or not move the TV sideways or out, that they are those that can extend its neck. In addition to the measurements of your equipment, you should make your choice of support considering the type of wall on which will be installed. Solid walls would need if, for example, a support can be extended forward. Therefore, it prevents generally walls than brick or cement.
Another determining factor is where outlets are located. Avoid placing your TV support away from those, to avoid the mess of wires and make things easier. Before you begin, have at hand all the tools, including drill, pencil, level, ruler, stud finder and bolts own device. With few steps, you can achieve for your dresser TV stand frame that effect seen in movies thanks to a simple support and a moment of your time. Remember, when choosing the place where place, calculate the acceptable distance for the viewer with respect to the television image, while affecting ambient light and viewing angle. Once you find the joists, you mark them with an “X”. Then the bracket supports against the wall and mark the holes where to install the bracket. Here, taking care that uses the drill bit size or wick is correct with respect to the screws. The support must be absolutely firm and safe against the wall. It is very important that you make sure the strength of the wall, using at least one beam to install the dresser TV stand, because otherwise you run the risk of collapse. For the last step you need one or two pairs of hands to help you, so that you can screw the TV to the stand. Do not spare time to corroborate that each screw is tight.